⬑ Back to All Videos

Norden Mfg Videos

tie-grabbers

TODO: Add description

Norden Mfg – Grabber & Tie-Grabber for Small Square Bales

The patented Norden Grabbers and Tie-Grabbers take over the back-breaking work of lifting and stacking hay bales on the truck or wagon.  For producers with longer, rougher hauls to the barn, and to help ensure a safer, sturdier stack, we developed…

Why Norden Hay Accumulator

Watch the Norden Mfg (formerly Kuhns) Hay Accumulator work its wonders in the field. Small square bale handling has been difficult for many years. Find out how this accumulator can turn this historically difficult task into something one person can…

How to Adjust the Norden MFG Tie-Grabber Arm Valve

Does your knotter not tie when the twine arm comes around? Does the knotter start cycling while the twine arm is coming around? In this video we show you simple steps to help fix these issues. • First, if the twine arm comes around and the…

How to Adjust the Sequence Valves on the Norden MFG Tie-Grabber

How to Adjust the Sequence Valves on the Norden MFG Tie-Grabber…

How to Thread Twine through the Norden MFG Tie-Grabber

In this video we show you step by step, how to thread twine through your Norden MFG Tie Grabber. 1. Press and hold the lever/control for the “Twine Arm Forward” circuit to rotate the twine arm, to the position shown, approximately three feet…

Adjusting the Timing Finger and Cam on the Norden Tie-Grabber

Are you not getting a clean knot? Here are the steps to check your tucker finger and cam. • This will need to be adjusted if your twine is not making a knot or its hanging onto the bill hook. • First, take a look at the cam to check the…

Setting the Needle to the Correct Position on the Norden Tie-Grabber

Let’s go over how to set your needle to the correct position. The needle will need to be adjusted if you notice that the twine is slipping and not tying through the knotter. • What we’re looking for is when the twine arm has come into the…

Out of Sync Tucker Finger on the Norden Tie-Grabber

• The tucker finger becomes out of sync when the twine arm is coming into the knotter but the tucker finger is not in the downward position. • To make this adjustment, take your twine arm to the front of the knotter and safely tie it off.…

How to Hook Up the Switch Assembly on the Norden Tie Grabber

• Each tie-grabber comes with a switch assembly that allows you to switch from the hook squeeze mode to the tie mode. • Mount the provided splitter handle in the cab.• Each switch has two wires. • Then connect the red wire on the…

Norden Mfg KN615 Tie-Grabber on Bobcat S250

The Norden Mfg (Formerly Kuhns Mfg) Tie-Grabber places one strand of regular baler twine around a group or “grab” of hay bales. The Tie-Grabber works off of two hydraulic remotes. One remote runs the Squeeze Arm and the hooks, the other remote runs…